Magnadyne M3-LCD Troubleshooting Guide download pdf (Page 62)

ENGLISH

• You can adjust the crossover frequency within the

range of 40 ~ 250 Hz.

• Select "FULL RANGE" when the selected speaker

can fully reproduce the low frequencies below 40 Hz.

When selecting the SPEAKER CROSSOVER

󰥒Note :

• You cannot select the subwoofer and the speakers

set to "NO".

• Set the crossover frequency according to the frequency characteristics of the speakers connected.

(For details on the frequency characteristics, refer to the operating instructions of the speakers.)

• If the frequency range of your speaker is 100 Hz ~ 20 kHz, the crossover frequency should be set to 100 Hz

(or slightly higher).

• The low frequencies below the crossover frequency are to output from subwoofer or the speakers which are

set to "FULL RANGE" (when not using a subwoofer).

1. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the SPEAKER CROSSOVER, then press the

ENTER button.

2. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired speaker.

3. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the crossover frequency as desired.

4. Repeat the above steps 2 and 3 until the crossover frequencies are all set as desired.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 80 81

No comments

Magnadyne M3-LCD Troubleshooting Guide Page 62