Magnadyne M3-LCD Troubleshooting Guide download pdf (Page 23)

ENGLISH

Erasing the programmed command from

one button

• "OK" is displayed and then "SEL" is flickering.

• Then "BTTN" is displayed on the LCD screen for

several seconds.

Example: When the button for the command to be

erased is PLAY button.

• Each time the CURSOR UP(▲)/DOWN(▼)

buttons are pressed, "BTTN" or "LEARN"(all

command deleting mode) is selected.

• Then "SEL" is flickering.

• If "SEL" goes off, start again from the above

step 1.

1. Perform the steps 3 and 4 in "Entering a setup

code" procedure on page 20 to select the

deleting mode ("DELETE").

1. Perform the steps 3 and 4 in "Entering a setup

code" procedure on page 20 to select the

deleting mode ("DELETE").

2. While "BTTN" is displayed, press the CURSOR

UP(▲)/DOWN(▼) buttons to select the all

command deleting mode ("LEARN"), then press

the ENTER button.

3. While "SURE?" is displayed, press the ENTER

button.

4. To erase all the commands programmed under

other device mode, repeat the above steps 1 to

2. While "BTTN" is displayed, press the CURSOR

UP(▲)/DOWN(▼) buttons to select the one

command deleting mode (BTTN), then press the

ENTER button.

3. While "SEL" is flickering, press the button for the

command you want to erase.

4. While "SEL" is flickering, repeat the above step

3 to erase other commands.

Erasing all the commands programmed

under a device mode

• Then all the commands programmed are erased.

• Then "BTTN" is displayed on the LCD screen for

several seconds.

• Then "SURE?" is displayed .

• If "SURE?" goes off, start again from the above

step 1.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 80 81

Comments to this Manuals

No comments

Magnadyne M3-LCD Troubleshooting Guide Page 23

Comments to this Manuals

Related products and manuals for AV receivers Magnadyne M3-LCD