Magnadyne M3-LCD Troubleshooting Guide download pdf (Page 19)

ENGLISH

LOADING BATTERIES

OPERATING COMPONENTS WITH REMOTE CONTROL

REMOTE CONTROL OPERATION RANGE

• Use the remote control within a range of about 7

meters (23 feet) and angles of up to 30 degrees

aiming at the remote sensor.

•When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries

within several minutes after removing old batteries.

•If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be

cleared. Should this happen, you should memorize them again.

• Remove the batteries when they are not used

for a long time.

• Do not use the rechargeable batteries (Ni-Cd

type).

• Be sure to use alkaline batteries.

1. Enter the setup code for each component other

than this receiver. For details, refer to "Entering

a setup code" on page 20.

2. Turn on the component you want to operate.

1. Remove the cover.

2. Load four alkaline batteries ("AAA" size, 1.5V)

matching the polarity.

3. Press the DEVICE button on the remote control

corresponding to the component you wish to

operate.

4. Aim the remote control at the REMOTE

SENSOR of the component you wish to control

and press the button corresponding to the

operation you want.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 80 81

No comments

Magnadyne M3-LCD Troubleshooting Guide Page 19