Magnadyne MV-VCRUSER02 User Manual download pdf (Page 8)

6.4" Viewing Screen Controls and Functions

7. Transmitter Frequency Selection:

The Movievision

viewing screen transmits a signal that

is received by the Movievision

headphones and can also

be received by the vehicle’s car radio. There are 3 fre-

quencies available for use but only one can be used at a

time. When you are listening to a movie using the wireless

Movievision

headphones, it is possible that you could

travel through an area where interference between the

screen transmitter and the headphone receiver is at an un-

acceptable level. If this occurs, you can use the 3 position

frequency switch located in the roof housing to select a

different frequency that may have less or no interference.

Each time you change the transmitting frequency, the

headphone/car radio receiver will have to be re-tuned to

the new frequency. The 3 frequencies available for use are

89.7mhz, 90.1mhz or 90.5mhz. (For further information

on headphone tuning, consult the “Headphone Operation”

section of this manual)

Car Radio Interface:

The signal transmitted from the Movievision

screen can be

received by the existing FM car radio. This

listening mode provides a much higher quality of sound for

all. To listen to the Movievision

signal through the vehicle

stereo system, repeat the following procedures;

A. Turn “ON” the Movievision

system and insert a tape or

attach an auxiliary signal source to view on the screen.

B. Turn “ON” the FM radio in your vehicle and tune the radio

to one of the 3 frequencies transmitted by the

Movievision

system. (89.7mhz - 90.1mhz - 90.5mhz)

C. Adjust the volume and tonal qualities to suit your listen-

ing taste.

Transmitter Frequency Selection Switch

Stereo/Mono Switch

6. Stereo/Mono Switch:

If a condition of interference arises and it can not be reme-

died by selecting another frequency, changing the transmit

mode from “Stereo” to “Mono” usually will eliminate inter-

ference noise. The audio performance will be reduced when

the switch is placed in the “MO” position. Return the

“ST/MO” switch to the “ST” position to re-gain the high

performance stereo sound in the headphones or the

Vehicles stereo system.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Magnadyne MV-VCRUSER02 User Manual Page 8

Comments to this Manuals

Related products and manuals for Car video systems Magnadyne MV-VCRUSER02