Magnadyne MV-VCRUSER02 User Manual download pdf (Page 14)

Replacing Domelight Bulbs:

To replace a domelight bulb, repeat the following procedure.

Warning! in some cases, the domelight maybe hot, proceed

with caution.

1. Use your fingernail to pull the lever at the end of the

domelight lens forward and downward this will release the

lens to expose the bulb.

2. Use a pencil to pry out one end of the bulb then pull the

remaining end of the bulb out of it’s clip. Do not use any

metal device to remove the bulb as you may short the ter-

minals together.

3. To replace the bulb, place the metal ends of the new bulb

onto the metal clips and gently press inward until the bulb

ends are seated into the clips.

4. Replace the lens by setting the tab end into the slot and

then pressing the clip end into place.

Warning! Only replace the bulb with the same size

and wattage that you took out. Altering the size, shape

or wattage will result in a damaged housing (melting).

Use only Sylvania or GE model DE3021 for replacements.

Removing Bulb

Removing

Domelight Cover

6.4" and 10.4" Domelight Operation

Domelight Operation:

(Applies to MovieVision flip-down screen with dome lights

built-in only.)

The dome lights located in the MovieVision screen housing

will illuminate whenever the vehicle doors are open just as

the original domelight did.

To activate the dome lights while the vehicle is in motion,

press the domelight switch next to the desired domelight.

Note: Most American made vehicles (Ford, Chevrolet, Dodge)

have a dashboard light dimmer switch that can be rotated to

the maximum position and the dome lights will illuminate.

Most Japanese or Korean made vehicles do not have this

switch and the lights will have to be turned on manually as

mentioned above.

Domelight

Switch

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Magnadyne MV-VCRUSER02 User Manual Page 14